The LM2753 is capable of driving a flash LED with a pulsed current of 400 mA at an input voltage of 3.6 V. A switched-capacitor doubler, the LM2753 provides a regulated 5-V output (VOUT) over an input supply range of 3 V to 5.5 V. The switched output, IOUT, takes less than 10 ns to turn on and provide maximum current to a flash LED. Flash LED current is set via a ballast resistor. Continuous illumination current (torch mode) is programmed by connecting a resistor between IOUT and VOUT. This device uses only three small, low-cost ceramic capacitors.
The LM2753 device uses pulse frequency modulation (PFM) regulation. Typical operating frequency is 725 kHz. Under no-load conditions, the LM2753 operates on only 60 µA. If the output is connected to ground, the charge pump stays in the gain of 1, which helps limit the input current to 300 mA (typical).
For all available packages, see the orderable addendum at the end of the data sheet.| Input voltage type | Linear |
| Topology | Charge pump |
| Vin (min) (V) | 3 |
| Vin (max) (V) | 5.5 |
| Vout (max) (V) | 5 |
| Vout (min) (V) | 5 |
| Iout (max) (A) | 0.4 |
| Iq (typ) (mA) | 0.06 |
| Features | Enable |
| Operating temperature range (°C) | -40 to 85 |
| Number of channels | 1 |
| Rating | Catalog |
| WSON (DSC) | 10 | 9 mm² 3 x 3 |
关注公众号，优惠活动早知道！
Copyright ©2023 wlxmall.com万联芯城版权所有 | 电信与信息服务业务经营许可证100798号 | 粤ICP备14012234号 | 投诉建议
客服电话：4000-306-326 文明办网文明上网举报电话：010-82615762 违法不良信息举报中心
| * 我的问题/建议： | |
| * 联系电话： | |
| 上传图片（选填）： |
请您提交2M以内的jpg,gif,png格式文件 |
| 投诉订单号（选填）： | |
购物车中还没有商品，赶紧选购吧！
正在供货
加入购物车
